Alaska permit test: turns and lanes
Signal a turn continuously for the last 100 feet before you turn, and cancel the signal afterward. Use hand signals in bright sun or when following cars hide your lights. Get into the correct lane well ahead of a turn. If you are in the wrong lane, do not turn. Go around the block. Left turns from a two-way street go into the lane next to the center line. Do not cut corners. Do not pass on the right shoulder, on approach to a hill or curve you cannot see over, or when a solid yellow line is in your lane. Do not pass within 100 feet of an intersection, railroad crossing, or posted narrow bridge, viaduct, or tunnel. The end of a no-passing zone does not mean it is safe to pass. When another driver passes you, do not speed up. Center lanes are only for slowing down before a left turn. When you change lanes, check mirrors and blind spots, signal, and check again. On a freeway, use the acceleration lane to reach cruising speed, and use the deceleration lane to exit.
Handbook: Signaling (p. 30); Turns (pp. 31-32); Do Not Pass (p. 37); Highways (p. 58)
6 practice questions
- 50 feet
- 25 feet
- Only when other cars are close
- At least 100 feet
Show answer
Answer: D. At least 100 feet
A hand or turn signal must be given continuously during the last 100 feet before the turn. You may signal from farther away when traffic or high speed makes it wise, and you must cancel the signal afterward.
Handbook: Signaling (p. 30)
- On a straight road with a dashed yellow line in your lane
- Within 100 feet of an intersection or a railroad crossing
- On the left of a slow-moving vehicle when the road ahead is clear
- On a two-lane road in daylight with no oncoming traffic in sight
Show answer
Answer: B. Within 100 feet of an intersection or a railroad crossing
You may not pass when approaching within 100 feet of, or while crossing, an intersection or railroad crossing. A dashed yellow line permits passing only when it is safe and clear.
Handbook: Do Not Pass (p. 37)
- Your brake lights will stop working
- Your headlights will switch to low beam
- Others may turn or cross in front of you
- Your signal bulbs will burn out much faster
Show answer
Answer: C. Others may turn or cross in front of you
Alaska law requires you to cancel your signal after you use it. An unintended signal still tells other drivers you are turning, and one of them may pull out or cross in front of you.
Handbook: Signaling (p. 30)
- To pass a slower vehicle ahead of you
- To drive when the other lanes are slow
- To speed up before you merge into traffic
- Only to prepare for a left turn
Show answer
Answer: D. Only to prepare for a left turn
Center lanes are for slowing down in advance of a left turn. You may not use a shared center lane to drive, speed up, or pass.
Handbook: Do Not Pass (p. 37); Pavement Markings: Shared Center Lane (p. 55)
- Do not turn. Continue and go around the block
- Stop in the lane and wait for a gap to move over
- Turn anyway if you signal first
- Back up to the correct lane
Show answer
Answer: A. Do not turn. Continue and go around the block
Do not turn from the wrong lane, and do not hold up traffic while you try. Go around the block, and watch for no U-turn signs.
Handbook: Pavement Markings: item 8 (p. 57)
- Speed up to finish the pass sooner
- Do not speed up
- Move onto the right shoulder
- Brake hard so the driver can pull in front of you
Show answer
Answer: B. Do not speed up
It is unlawful to increase your speed when another vehicle is passing you. Safe passing depends on both drivers cooperating, and driving on the shoulder is not allowed.
Handbook: Do Not Pass (p. 37); Major Roads: Passing (p. 57)