Get the Pass

Georgia permit test: turns and lanes

Signal every turn for an adequate distance. For a right turn, approach in the right lane, yield to bicyclists in a bike lane, and end in the right lane of the new road. For a left turn, move into the far left lane or the turn lane, keep your wheels straight until you start, yield to oncoming traffic, and stop for pedestrians. Once you are inside the intersection, do not change lanes. On a two-lane road, you may pass only in a passing zone. You must be back in your lane before oncoming traffic is within 200 feet. Passing is not allowed within 100 feet of a railroad crossing, bridge, viaduct, or tunnel. It is also not allowed on hills or curves with limited view, or on the shoulder. The Slow Poke law says slower drivers must leave the passing lane when faster traffic approaches, with a few exceptions such as turning left. At a roundabout, yield to circulating traffic and enter counterclockwise. In a multilane roundabout, keep your lane. When you enter an expressway, do not cross the solid white line of the gore.

Handbook: Section 5: Traffic Laws - Passing

7 practice questions

1. You are making a left turn and waiting in the intersection for a gap in traffic. Where should your front wheels point?
  1. Toward the left, ready to turn
  2. Toward the right, to keep a safe gap
  3. Straight ahead, until you begin the turn
  4. It does not matter if you signal
Show answer

Answer: C. Straight ahead, until you begin the turn

Keep your wheels straight until you start the turn. If another car hits you from behind, straight wheels will not push you into oncoming traffic.

Handbook: Section 5: Traffic Laws - How To Make A Left Turn

2. On a two-lane road, where is passing prohibited?
  1. Anywhere there is a broken yellow line on your side
  2. Any place where the car ahead is under the speed limit
  3. Only within 50 feet of a school
  4. Within 100 feet of a railroad crossing or bridge
Show answer

Answer: D. Within 100 feet of a railroad crossing or bridge

Passing is prohibited within 100 feet of a railroad crossing, bridge, viaduct, or tunnel. It is also prohibited on solid-line zones and on hills or curves with limited view.

Handbook: Section 5: Traffic Laws - Passing

3. You are in the left lane of a multi-lane road and a faster car comes up behind you. What does Georgia's "Slow Poke" law require?
  1. Stay in the lane, as long as you drive at the speed limit
  2. Speed up to stay ahead of the faster car behind you
  3. Stay in the lane, if the right lane is busy with traffic
  4. Move out of the passing lane, whatever your speed
Show answer

Answer: D. Move out of the passing lane, whatever your speed

Slower drivers must leave the passing lane, which is usually the left lane, when faster traffic approaches. This applies regardless of your speed, with a few exceptions such as turning left or heavy traffic.

Handbook: Section 5: Traffic Laws - Keep Right, Except to Pass

4. You turn right at an intersection, and a bicycle lane runs along the curb. What must you do?
  1. Wait in the bicycle lane until the way is clear
  2. Turn from the bicycle lane to stay close to the curb
  3. Yield to bicyclists, then cross the lane to turn
  4. Pass the bicyclist and turn in front of them
Show answer

Answer: C. Yield to bicyclists, then cross the lane to turn

Drivers may not drive in a bicycle lane except to cross it to make a turn. Before you cross it, you must yield to bicyclists who are there.

Handbook: Section 7: Signs, Signals & Markings - Pavement Markings - Bicycle Lanes

5. You have entered an intersection to make a left turn. What may you NOT do?
  1. Complete the turn at a safe speed
  2. Yield to oncoming traffic
  3. Change lanes inside the intersection
  4. Stop for pedestrians in the crosswalk
Show answer

Answer: C. Change lanes inside the intersection

Once you enter an intersection to make a left turn, you cannot change lanes in it. Finish the turn so you end up in the lane that matches the one you started in.

Handbook: Section 5: Traffic Laws - How To Make A Left Turn

6. You enter an expressway from an acceleration lane. A solid white line separates you from the main lane. What does the law require?
  1. Cross the line as soon as you reach highway speed
  2. Stop at the end of the ramp and wait for a gap
  3. Cross the line if no one is in the main lane
  4. Stay in the acceleration lane until the line ends
Show answer

Answer: D. Stay in the acceleration lane until the line ends

The area between the lanes, bounded by solid white lines, is called a gore. Drivers entering a controlled access highway must not cross the solid white line and must stay in the acceleration lane until it disappears.

Handbook: Section 8: Safety Guidelines - Expressway Driving - Gores

7. You approach a multilane roundabout. What must you do inside it?
  1. Move to the inside lane as soon as you enter
  2. Change lanes to pass slower cars
  3. Stop in the circle for pedestrians
  4. Keep your lane and do not change lanes
Show answer

Answer: D. Keep your lane and do not change lanes

In a multilane roundabout, you pick the correct lane before you enter, yield to circulating cars in both lanes, and stay in your lane. Pedestrians have the right of way at the crosswalks on entry and exit, not in the circle.

Handbook: Section 7: Signs, Signals & Markings - Roundabouts