Idaho permit test: turns and lanes
Signal at least 100 feet before a turn or lane change in business or residential areas. On freeways and highways, signal at least five seconds ahead. Also signal when you exit a roundabout, pull away from the curb or pull over. For a right turn, stay close to the right curb and do not swing wide. For a left turn, use the lane closest to the left and do not cut the corner. A U-turn is not legal where drivers cannot see you within 500 feet, such as on a curve or near a hill crest. Keep to the right side of the road, except to pass or turn left. Do not pass within 100 feet of an intersection, a railroad crossing or an obstructed bridge or tunnel. Do not pass where you cannot see oncoming traffic. Pass on the right only when the vehicle ahead is turning left on a two-lane road, or on a road with two or more lanes in your direction. Finish a pass before you come within 200 feet of oncoming traffic. On a freeway, yield to traffic when you merge and never back up or use a median crossover.
Handbook: Driver's Handbook (July 2026), Traffic Laws & the Rules of the Road: Turns, Keep to the Right, Passing, Freeway Driving
7 practice questions
- At least 5 seconds
- At least 1 second
- At least 2 seconds
- Only when you start to move
Show answer
Answer: A. At least 5 seconds
In business or residential areas, signal at least 100 feet before the turn or lane change. On freeways or highways, signal at least five seconds before. Signaling early helps prevent rear-end crashes.
Handbook: Driver's Handbook (July 2026), Traffic Laws & the Rules of the Road: Turns
- On a straight rural road with no traffic
- On any road with a dashed white line
- On the left side of a one-way street
- Within 100 feet of a railroad crossing
Show answer
Answer: D. Within 100 feet of a railroad crossing
You may not pass within 100 feet of an intersection or railroad crossing, unless traffic control devices say otherwise. You also may not pass on hills or curves where you cannot see oncoming traffic.
Handbook: Driver's Handbook (July 2026), Traffic Laws & the Rules of the Road: Passing
- Stop at the end of the ramp and wait there for a gap
- Merge at ramp speed and let freeway traffic slow down for you
- Speed up to match traffic and yield to cars on the freeway
- Drive on the shoulder until a gap appears
Show answer
Answer: C. Speed up to match traffic and yield to cars on the freeway
You must yield to traffic already on the freeway. Use the ramp and acceleration lane to reach the speed of traffic, signal, look over your left shoulder, and blend into a gap.
Handbook: Driver's Handbook (July 2026), Highway & Vehicle Knowledge: Freeway Driving, Entering a Freeway
- On a residential street where the speed limit is 25 mph or lower
- At an intersection that has a stop sign on each of the four corners
- On a curve or near the crest of a hill that hides you from view
- On a road that has a wide shoulder where you could pull off to turn
Show answer
Answer: C. On a curve or near the crest of a hill that hides you from view
A U-turn is not legal on a curve, near the crest of a hill, or anywhere that approaching drivers cannot see you from 500 feet in both directions. Stop and yield to all traffic before you complete a U-turn.
Handbook: Driver's Handbook (July 2026), Traffic Laws & the Rules of the Road: Turns, U-Turns
- When the vehicle ahead is slow and the road has a wide, clear shoulder
- When the driver ahead waves you by, and no other cars are in sight
- When the vehicle ahead signals a left turn, and you stay on pavement
- At no time, because passing on the right is never legal on any road
Show answer
Answer: C. When the vehicle ahead signals a left turn, and you stay on pavement
You may pass on the right on a two-lane road only when the vehicle ahead is signaling a left turn. You may also do so on a one-way street or a road with two or more lanes in your direction. Never drive off the roadway to pass.
Handbook: Driver's Handbook (July 2026), Traffic Laws & the Rules of the Road: Passing, Passing on the Right
- Stop on the shoulder and back up the ramp to the road you came from
- Use the median crossover to turn around when no traffic is coming
- Go on to the next exit and leave there to change direction
- Slow down to 25 mph and make a U-turn in the left lane of the freeway
Show answer
Answer: C. Go on to the next exit and leave there to change direction
Never back up or turn around on a freeway. Median crossovers are for maintenance and emergency vehicles only. Wait for the next exit to change direction.
Handbook: Driver's Handbook (July 2026), Traffic Laws & the Rules of the Road: Freeway Driving, Entering a Freeway
- 50 feet
- 100 feet
- 500 feet
- 200 feet
Show answer
Answer: D. 200 feet
Complete a pass before you come within 200 feet of oncoming traffic. Also finish before you reach a no-passing zone that signs or pavement markings show.
Handbook: Driver's Handbook (July 2026), Traffic Laws & the Rules of the Road: Passing, When Passing Other Vehicles