Get the Pass

Indiana permit test: signals and pavement markings

Green means go when the intersection is clear. A steady yellow means your right of way is ending, and you may finish your movement if you are too close to stop safely. A red light means stop at the solid white stop line, and you may not enter until it turns green and the intersection is clear. A flashing red light works like a stop sign. A flashing yellow light means slow down and use caution, and left-turning drivers must yield to oncoming traffic and pedestrians. A flashing yellow arrow means turn only after you yield to pedestrians and oncoming traffic. At a pedestrian hybrid beacon, the signal is dark until a pedestrian activates it. It then goes through flashing yellow, steady yellow and two steady red lights. When the two red lights flash, you may go if no one is in the crossing. If a signal is not working, stop before the intersection and proceed with caution after you yield. Yellow lines separate opposing traffic, and you should not cross a solid yellow line except to turn. White lines separate lanes that go the same way, and you should not cross a solid white line.

Handbook: Chapter 6: Traffic Signs and Signals; Chapter 7: Lane Markings

8 practice questions

1. You are on a two-lane road with a solid yellow line on your side of the center line. What may you do?
  1. Cross it to pass if the road ahead looks clear
  2. Cross it to pass slow vehicles on a straight road
  3. Cross it only to make a turn
  4. Cross it any time after you signal for three seconds
Show answer

Answer: C. Cross it only to make a turn

You should not cross a solid yellow line except to turn. Passing across a solid yellow line on your side of the road is illegal even when no one is coming.

Handbook: Chapter 7: Safe Vehicle Operation - Lane Markings

2. A road has three lanes in your direction, separated by broken white lines. What do the broken white lines mean?
  1. You may cross them when it is safe to change lanes
  2. You must never cross them under any condition
  3. They separate traffic that travels in opposite directions
  4. They mark a lane that is reserved for buses
Show answer

Answer: A. You may cross them when it is safe to change lanes

White lines separate traffic that travels in the same direction. You may cross a broken white line when it is safe, but you should not cross a solid white line.

Handbook: Chapter 7: Safe Vehicle Operation - Lane Markings

3. You approach an intersection and the signal is a flashing red light. What must you do?
  1. Stop completely, then go ahead with care when it is safe
  2. Slow down and go through if the road looks clear
  3. Go through, because cross traffic must stop
  4. Stop only if other cars are waiting in the other lanes
Show answer

Answer: A. Stop completely, then go ahead with care when it is safe

A flashing red light works like a stop sign. You must make a complete stop and then go only when the intersection is clear and you will not take another driver's right-of-way.

Handbook: Chapter 6: Traffic Signs and Signals - Red Flashing Lights

4. What does a flashing yellow light (without an arrow) at an intersection mean?
  1. Slow down and use caution; if you turn left, yield to oncoming traffic
  2. Stop and wait for the signal to change to green before you go on
  3. Cross traffic has the right-of-way, so you must yield to the cross street
  4. Stop, then go through the intersection only after a full three seconds
Show answer

Answer: A. Slow down and use caution; if you turn left, yield to oncoming traffic

A flashing yellow light tells you to slow down and use caution. Drivers on the cross street must yield to you, but you must still yield to oncoming traffic and pedestrians when you turn left.

Handbook: Chapter 6: Traffic Signs and Signals - Yellow Flashing Lights

5. You are approaching an intersection and the light turns steady yellow. You are too close to stop safely. What should you do?
  1. Complete your movement through the intersection
  2. Brake hard and stop in the crosswalk
  3. Back up so that you stop before the stop line
  4. Speed up and drive through at the highest legal speed
Show answer

Answer: A. Complete your movement through the intersection

A steady yellow means the green has ended and your right-of-way is ending. If you cannot stop safely, you may finish your movement. Stopping hard can cause a rear-end crash.

Handbook: Chapter 6: Traffic Signs and Signals - Traffic Signals; Driving through an Intersection

6. At a mid-block crosswalk, a pedestrian hybrid beacon shows two steady red lights. What does this mean for drivers?
  1. Stop and stay stopped while the pedestrian crosses
  2. Slow down and pass if no one is on your side
  3. Stop only if a pedestrian is directly in front of you
  4. Go ahead, because the beacon only applies to buses
Show answer

Answer: A. Stop and stay stopped while the pedestrian crosses

Two steady red lights are shown while the pedestrian crosses, so drivers must stop. When the red lights flash, you may go on if the crossing is clear of pedestrians.

Handbook: Chapter 6: Traffic Signs and Signals - Pedestrian Hybrid Beacons

7. You reach an intersection where the traffic signal is not working at all. What must you do first?
  1. Slow down and keep going if no one is close
  2. Treat it as a green light and drive on
  3. Wait for the driver on your left to wave you through
  4. Stop before entering the intersection
Show answer

Answer: D. Stop before entering the intersection

At a non-operating signal you must stop, and then you may go ahead with care after you yield to cross traffic already in the intersection, vehicles that stopped before you, vehicles that arrived with you on your right, and pedestrians.

Handbook: Chapter 6: Traffic Signs and Signals - Approaching an Intersection with Non-Operating Signal

8. You see a pavement marking of a bicycle with two arrows above it (a sharrow) in your lane. What does it tell you?
  1. Only bicycles may use this lane, and cars must use the next lane
  2. The lane is reserved for buses and taxis at all times of day
  3. Expect cyclists to use the travel lane, and share it with them
  4. Cyclists must ride on the sidewalk on any road with this marking
Show answer

Answer: C. Expect cyclists to use the travel lane, and share it with them

Sharrows help cyclists position themselves away from parked cars and warn other road users that cyclists will use the travel lane. Cars may still use the lane.

Handbook: Chapter 7: Safe Vehicle Operation - Sharrows