Get the Pass

Texas permit test: turns and lanes

Signal for at least 100 feet before a turn or a stop, and turn the signal off when the turn is done. You must also signal to change lanes, to pull away from a curb, to enter or leave a highway, and to pull over. Decide early. If you cannot reach the proper lane within one-half block before the turn, go straight. Slow down at least 100 feet from the corner and use both hands to turn. For a left turn, yield to oncoming traffic and turn to the right of the center line of the new road. Never drive on the left side of the road to pass within 100 feet of an intersection, railroad crossing, bridge, viaduct, or tunnel. Do not pass on a hill or curve, or where lines forbid it. On a two-lane road, be back in your lane before an oncoming car is within 200 feet. You may pass on the right on a one-way road or a wide, clear multi-lane road. The center lane is only for left turns. In a roundabout, yield to traffic in the circle, go counterclockwise, and do not change lanes in the circle.

Handbook: Chapter 6: Signaling, Passing, and Turning (pp. 38–41); Chapter 9 – Roundabouts (pp. 49–50)

7 practice questions

1. How far before a turn must you start to signal?
  1. At least 50 feet
  2. At least 100 feet
  3. At least 300 feet
  4. Only when you begin to turn the wheel
Show answer

Answer: B. At least 100 feet

Give the proper turn signal at least 100 feet before you turn, and signal continuously. A signal given only as you turn gives other drivers no time to react. Turn the signal off after the turn, because a signal left on still means 'turn' to other drivers.

Handbook: Chapter 6: Signaling, Passing, and Turning – Signaling: How to Signal (p. 38); Turning, step 4 (p. 40)

2. You are driving in a modern roundabout when you hear a siren behind you. What should you do?
  1. Stop at once inside the circle
  2. Stop next to the center island and let the vehicle pass
  3. Drive around the circle a second time until it passes
  4. Continue to your exit, leave the circle, and then pull over
Show answer

Answer: D. Continue to your exit, leave the circle, and then pull over

Do not stop for an emergency vehicle inside a roundabout circle. Clear the circle first, then pull over. Traffic in a roundabout moves counterclockwise, and drivers who enter must yield to traffic already in the circle.

Handbook: Chapter 9: Some Special Driving Situations – Roundabouts (pp. 49–50)

3. On a two-lane road, where does Texas law prohibit you from driving on the left side of the road to pass?
  1. Within 100 feet of an intersection, a railroad crossing, or a bridge
  2. Anywhere a broken yellow line is on your side of the road
  3. On any straight, level road during daylight hours
  4. Within 300 feet of a vehicle parked on the shoulder
Show answer

Answer: A. Within 100 feet of an intersection, a railroad crossing, or a bridge

You must not drive on the left side of the road within 100 feet of, or while crossing, an intersection or railroad crossing, or within 100 feet of a bridge, viaduct, or tunnel. You also must not pass on a hill, on a curve, or anywhere your view is limited. A broken line on your side lets you pass when it is safe.

Handbook: Chapter 6: Signaling, Passing, and Turning – Passing: Keep to the Right (p. 38); Chapter 5 – Solid and Broken Lines (p. 34)

4. In Texas, when may you pass another vehicle on the right if it is safe?
  1. On any two-lane road with a broken line
  2. By driving on the unpaved shoulder
  3. On a one-way road
  4. Whenever the car ahead drives slowly
Show answer

Answer: C. On a one-way road

Passing on the right is allowed when conditions permit, such as on a one-way road. You may not drive off the paved part of the highway to pass on the right.

Handbook: Chapter 6: Signaling, Passing, and Turning – Passing on the Right (p. 39)

5. You pass a car on a two-lane road. By when must you be back in the right lane?
  1. Before an oncoming car is within 50 feet
  2. Before you pass the next driveway
  3. Before an oncoming car is within 200 feet
  4. Within five seconds of the start of the pass
Show answer

Answer: C. Before an oncoming car is within 200 feet

Check for oncoming traffic and make sure you have time to pass and return to the right lane before an approaching car comes within 200 feet. Do not return until you see the passed car in your rearview mirror.

Handbook: Chapter 6: Signaling, Passing, and Turning – How to Pass on a Two-Lane Road, step 2 (p. 39)

6. You cannot get into the proper lane within one-half block before your turn. What should you do?
  1. Turn from the lane you are in
  2. Stop and back up into the proper lane when it is clear
  3. Do not turn, and continue straight ahead
  4. Signal and cut across the other lanes very quickly
Show answer

Answer: C. Do not turn, and continue straight ahead

A last-minute turn is dangerous. If you cannot reach the proper lane within one-half block, skip the turn and go straight ahead.

Handbook: Chapter 6: Signaling, Passing, and Turning – Turning, step 3 (p. 39)

7. You drive in the circle of a multi-lane roundabout. What should you do about lanes?
  1. Move to the inside lane to pass slow traffic
  2. Stop in the circle to let large trucks pass
  3. Cut across lane lines to take the shortest path
  4. Stay in your lane and do not change lanes
Show answer

Answer: D. Stay in your lane and do not change lanes

In a multi-lane roundabout you choose your lane before you enter and do not change lanes in the circle. Also give extra room to trucks and buses that need more than one lane.

Handbook: Chapter 9: Some Special Driving Situations – Roundabouts: Multi-lane roundabouts (p. 50)