Utah permit test: turns and lanes
Signal for at least two seconds before every turn and lane change. Check mirrors, signal, do a head check over your shoulder, and then merge when it is safe. Never change lanes inside an intersection. When you turn onto a multi-lane road, finish the turn in the lane that matches the one you started from. On multi-lane roads, stay in the right lane unless you pass or the lane is blocked. If a faster car comes up behind you in the left lane, move safely to the right, or you may be cited for impeding traffic. Do not cross or drive in a gore area. At a congested merge, use the zipper method and take turns. In a shared center left-turn lane, do not enter more than 500 feet before your turn. Roundabouts flow counterclockwise. Slow down, yield to oncoming traffic and pedestrians, and enter when clear. Never pass before a railroad crossing or bridge, at an intersection, or where a hill or curve blocks your view.
Handbook: Section 8.C, 8.E, 8.F and 8.I: Lane Changes, Passing, Signaling, Turns
7 practice questions
- For half a second
- For at least two seconds
- Only for one second
- Only if other cars are nearby
Show answer
Answer: B. For at least two seconds
The handbook says to signal for two seconds before turning and before beginning any lane change. Cancel the signal when you finish.
Handbook: Section 8.F: Signaling
- The lane farthest to the right
- Any lane with the least traffic
- The lane that matches the one you turned from
- The lane next to the center line
Show answer
Answer: C. The lane that matches the one you turned from
Finish the turn in the lane that corresponds to the lane you started from. Move to another lane only after the turn is complete.
Handbook: Section 8.C: Lane Changes (Proper Lane Usage)
- Merge early and never use the closing lane
- Use both lanes to the merge point, then alternate
- Let the faster lane go first every time
- Speed up so you are ahead of the other lane
Show answer
Answer: B. Use both lanes to the merge point, then alternate
Under the zipper method, drivers use both lanes until the merge point and then alternate, yielding into the single lane.
Handbook: Section 8.C: Lane Changes (Merging and Gore Area)
- No more than 50 feet
- No more than 150 feet
- As far as you like
- No more than 500 feet
Show answer
Answer: D. No more than 500 feet
You may not enter a shared left-turn lane more than 500 feet before the turn unless the last car is more than 500 feet from the intersection.
Handbook: Section 9.D: Pavement Markings (Shared Center Left Turn Lane)
- Stay in the left lane because you are at the speed limit
- Speed up so the car stays behind you
- Brake gently so the car backs off
- Move safely to the right so the car can pass
Show answer
Answer: D. Move safely to the right so the car can pass
A vehicle in the left lane must move safely to the right when approached from behind. You can be cited for impeding traffic if you do not.
Handbook: Section 9.B: Freeway Driving
- Clockwise
- Counterclockwise
- Straight across the middle
- In either direction, as long as you yield
Show answer
Answer: B. Counterclockwise
The handbook defines a roundabout as a circular intersection that flows counterclockwise. Slow down, yield to oncoming traffic and pedestrians, and enter when it is clear.
Handbook: Section 1: Definitions; Section 9.F: Roundabouts
- Just before a railroad crossing or bridge
- On a straight, open road with a broken yellow line on your side
- On a multi-lane road, in the left lane
- On a road with no oncoming traffic in sight
Show answer
Answer: A. Just before a railroad crossing or bridge
The handbook says never to pass before a railroad crossing or bridge, at intersections, in no-passing zones, on curves or hills that block your view, or around a car stopped at a crosswalk.
Handbook: Section 8.E: Passing