Get the Pass

Washington permit test: turns and lanes

Signal at least 100 feet before you turn. When you turn, stay in your original lane if there is more than 1 turn lane, then change lanes after the turn is complete. Check behind for bicyclists and yield to them before you turn. Once you are in a turn lane, you must make the turn. U-turns are generally allowed unless a sign forbids them. Do not make a U-turn on a curve or near the crest of a hill, because you need clear visibility. Keep right except to pass, and use the left lane to pass slower traffic while obeying the speed limit. Carpool lanes are not passing lanes. Do not use the shoulder to pass unless officials or signs direct you. Do not back up on a shoulder or freeway. Do not hitchhike or pick up hitchhikers on freeways. When merging onto an interstate, use the whole on-ramp, signal and check your mirrors. Drivers already on the road have the right-of-way. In slow traffic at a lane closure, use a zipper merge and take turns.

Handbook: Chapter 4: Roads - 4.14 Turning and 4.10 Traffic laws

7 practice questions

1. How far before a turn must you signal?
  1. At least 25 feet
  2. At least 50 feet
  3. At least 300 feet
  4. At least 100 feet
Show answer

Answer: D. At least 100 feet

Signal at least 100 feet before you turn. Make sure the signal stops blinking after the turn.

Handbook: Chapter 4: Roads - 4.14 Turning

2. There are 2 turn lanes and you are turning. What should you do during the turn?
  1. Stay in your lane until the turn is done
  2. Drift into the lane you prefer
  3. Move to the outside lane mid-turn
  4. Change lanes as you enter the turn
Show answer

Answer: A. Stay in your lane until the turn is done

With more than 1 turn lane, stay in your original lane through the turn. You may change lanes after you complete it.

Handbook: Chapter 4: Roads - 4.14 Turning

3. What is the Washington rule for U-turns?
  1. Forbidden unless a sign allows them
  2. Allowed unless a sign forbids them
  3. Allowed only at traffic lights
  4. Allowed only on one-way streets
Show answer

Answer: B. Allowed unless a sign forbids them

U-turns are generally allowed unless a sign says otherwise. You still need clear visibility, so do not turn on a curve or near a hill crest.

Handbook: Chapter 4: Roads - 4.14 Turning (U-turns)

4. On a road with several lanes in your direction, which lane should you use unless you are passing?
  1. The left lane
  2. The middle lane
  3. The right lane
  4. The carpool lane
Show answer

Answer: C. The right lane

Keep right except to pass. Use the left lane to pass slower traffic and obey the speed limit while you do.

Handbook: Chapter 4: Roads - 4.10 Traffic laws (General driving guidance)

5. May you drive on the shoulder to pass slower traffic?
  1. Yes, if the shoulder is wide enough
  2. Yes, if you use hazard lights
  3. Yes, at speeds under 25 mph
  4. No, not unless signs or officials direct it
Show answer

Answer: D. No, not unless signs or officials direct it

Do not use the shoulder to pass. Drive on it only when officials or signs direct you to.

Handbook: Chapter 4: Roads - 4.10 Traffic laws (General driving guidance)

6. In slow traffic where a lane is closing, how do you zipper merge?
  1. Use both lanes, then take turns merging
  2. Merge early and block the closing lane
  3. Speed up to pass the line of cars
  4. Stop and wait until all traffic clears
Show answer

Answer: A. Use both lanes, then take turns merging

Stay in your lane until the designated merge area, then alternate with the other lane. This keeps traffic predictable and moving.

Handbook: Chapter 5: Hazards - 5.3 Merging (Zipper merging)

7. Once you are in a turn lane, what must you do?
  1. Go straight if traffic is light
  2. Follow through with the turn
  3. Change lanes before the intersection
  4. Turn only on a green light
Show answer

Answer: B. Follow through with the turn

Once you are in a turn lane, you must follow through with the turn. Choose your lane early.

Handbook: Chapter 4: Roads - 4.16 Road markings