South Carolina permit test: speed limits
The manual does not list statutory speed limits, so always follow the speed limit sign. A speed limit sign gives the maximum legal speed in ideal conditions. You must drive slower when weather, traffic or road conditions are poor. Reduce speed at the first sign of rain, snow, sleet or ice, because tires grip less and stopping takes longer. To avoid hydroplaning, slow down on wet roads and through puddles. Reduce speed before you enter a curve, especially when traction is poor, when you follow another vehicle, or when you cannot see the end of the curve. Hard braking after you enter a curve can make tires lose traction. Reduce speed in work zones even when no workers are present, and do not tailgate. In a school zone with flashing lights or children present, you must obey the slower speed limit. Drive slower than the limit near playgrounds and residential areas where children may run out. When you tow a trailer, the manual advises a maximum of about 55 mph for most combinations, and you should never exceed the posted limit. At 50 mph on dry pavement, braking alone can take about 158 feet.
Handbook: Section 8: Safe Driving Tips – Speed Management
6 practice questions
- The speed you should always drive
- The minimum safe speed in bad weather
- The maximum legal speed in ideal conditions
- The speed for school zones only
Show answer
Answer: C. The maximum legal speed in ideal conditions
A posted limit is a maximum for ideal conditions. You must drive slower when weather, traffic or the road calls for it.
Handbook: Section 6: Rules of the Road – Speed Limit Signs
- Only after your tires start to slide
- Only when you can see other cars slowing
- Only when the road is covered completely
- At the first sign of wet or slippery conditions
Show answer
Answer: D. At the first sign of wet or slippery conditions
Tires grip less on slippery roads, so stopping takes longer and turning is harder. Reduce speed early.
Handbook: Section 8: Safe Driving Tips – Speed Management
- Slow down when driving on wet roads or through standing water
- Brake hard as soon as you feel the tires lift
- Speed up to cross the water faster
- Turn the steering wheel sharply left and right
Show answer
Answer: A. Slow down when driving on wet roads or through standing water
Hydroplaning happens when the tires ride on a layer of water. Lower speed keeps the tires in contact with the road.
Handbook: Section 8: Safe Driving Tips – Speed Management
- Brake hard after you are in the curve
- Reduce speed before you enter the curve
- Speed up before you enter to stay steady
- Hold your speed unless the curve is sharp
Show answer
Answer: B. Reduce speed before you enter the curve
Slow to a safe speed before the curve. Hard braking after entry can make tires lose traction.
Handbook: Section 8: Safe Driving Tips – Speed Management
- Keep your normal speed until you see workers
- Speed up to leave the zone sooner
- Reduce your speed anyway
- Use the left lane to pass slow traffic
Show answer
Answer: C. Reduce your speed anyway
Narrow lanes and rough pavement make work zones hazardous even when workers are absent. Keep reduced speed until you see End Road Work.
Handbook: Section 11: Special Driving Situations – Work Zones
- Drive at the normal limit if no crossing guard is present
- Drive 10 mph over the limit to clear the area
- Stop completely until the lights turn off
- Obey the slower school zone speed limit
Show answer
Answer: D. Obey the slower school zone speed limit
In a school zone with flashing lights or children present, you must obey the lower speed limit.
Handbook: Section 10: Sharing the Road – Pedestrians